Vega Technology Limited - Presentation Technology Specialist

Enquiry & Comment

FAQ

	Home > Contacts > FAQ

Projector

Problem Try these Solutions

No power

	Plug the projector into the AC outlet.
	Be sure READY indicator light is On.
	Wait 90 seconds after the projector is turned OFF before turning the projector back on. Note: After pressing the power ON-OFF switch to OFF, make sure the projector as follows : 1. The LAMP indicator will light and the READY indicator will turn off. 2. After 90 seconds, the READY indicator will light green again and the projector may be turned on by pressing the power ON-OFF button.
	Check the TEMPERATURE WARNING indicator. If the indicator flashes red, the projector cannot be turned on.
	Check the Projection Lamp.

Image is out of focus

Adjust the focus.

Make sure the projection screen is at least 4.6'(1.4m) from the projector.

Check the projection lens to see if it needs cleaning.

NOTE : Moving the projector from a cool temperature location to a warm temperature location may result in moisture condensation on the lens. In such an event, leave the projector OFF and wait until condensation disappears.

Picture is Left /

Right reversed

Check Ceiling / Rear feature.

Picture is Top /

Bottom reversed

Check Ceiling feature.

Some displays are not seen during the Operation

Check Display feature.

No image

	Check the connection between the computer or video equipment and the projector.
	When turning the projector on, it takes about 30 seconds to display the image.
	Make sure the temperature is not out of the Operating Temperature. (5'c 35'c)

No sound

	Check audio cable connection from audio input source.
	Adjust the audio source.
	Press VOLUME ( + ) button.
	Press MUTE button.

Remote Control Unit does not work

	Check the batteries.
	Check the ON -OFF switch on the Remote Control Unit is set to "ON".
	Make sure nothing is between the Remote Receiver and the Remote Control Unit.
	Make sure you are not too far from the projector when using the Remote Control Unit. Maximum operation range is 16.4' (Sm).

Wireless Mouse function does not work

	Check the cable connection between the projector and the computer.
	Check the mouse setting on your computer.
	Turn the projector on before you turn on the computer.

WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.

If the problem still persists after following all operating instructions, contact the sales dealer where you purchased the projector or the service center. Give the model number and explain the difficulty. We will advise you how to obtain service.